Awabot One robot - Battery replacement

This guide provides step-by-step instructions for replacing the battery in your Awabot One robot.

Required tools

• Long Arm M4 Allen Wrench (or 4 mm Hex Tool)
• Scissors
• 3 Zip Ties
• Helper (Recommended)
• Original Foam Packing (Recommended)

1. Prep your robot: Power down the robot's head by pressing the power button located to the left of the face.
2. Prep your workspace: Gently lay the robot on its face to expose the bottom of the unit.

Note: Use the original robot packing foam to protect the head and stabilize the base during this process.

3. Remove base screws: Use an M4 Allen wrench to remove all 13 screws from the bottom of the base.
4. Reposition the robot: Support the neck and base while you return the robot to an upright position.
5. Expose wiring: Carefully lift the head and stem away from the base to access the internal wiring.
6. Cut zip ties: Have a helper carefully cut all existing zip ties.
7. Disconnect interface cables: Disconnect the power cable connector and USB cables to fully release the head and stem from the base.
8. Remove battery strap: Unscrew the two screws holding the battery strap in place.
9. Disconnect power cables: Disconnect the battery and charger power cables.
10. Extract battery: Lift the battery up and out of the battery pocket.
11. Install new battery: Repeat steps 1 through 10 in reverse order to connect and secure your new battery.